top of page
JRH Engineering | Civil | Structural | Land Development
CASE STUDIES

Metal Building Foundation Design in Alvin, TX

Alvin · Brazoria County · Texas

Structural Engineering

Small metal building on a concrete slab foundation in Alvin, Texas

A compact building, designed with the same care as a large one

JRH Engineering designed the foundation for a pre-engineered metal building in Alvin, Brazoria County, Texas, about 43 by 22 feet. The metal building supplier provided the columns and anchor bolt locations. JRH designed a slab and grade beams with added reinforcement at each column, and delivered sealed plans for the client to submit to the City of Alvin.

AT A GLANCE

Project facts

  • Project type: metal building foundation, structural engineering

  • Location: Alvin, Brazoria County, Texas

  • Building size: about 43 by 22 feet (about 960 SF)

  • Building use: [to be confirmed]

  • Plans issued: August 2025

  • Client: confidential

Foundation design

  • 4-inch, 3,500 psi concrete slab

  • Grade beams with five continuous #5 bars top and bottom and #3 stirrups

  • Grade beam bump-outs where the building columns land

  • Extra #5 bars at 12 inches on center within 3 feet of each column

Anchor bolt coordination

  • Columns by the metal building supplier

  • Anchor bolt locations taken from the supplier's drawings

The Challenge: small building, concentrated loads

Even a small metal building delivers its load at a handful of columns. The foundation has to be stiff and strong at those points while keeping the slab simple and economical.

JRH's Approach: reinforce where the load lands

JRH added bump-outs to the grade beams at each column and extra slab reinforcement around them, so the loads from the supplier's frame have a clear path into the ground. The anchor bolts follow the supplier's drawings.

The Results

01

Sealed foundation plans for a 43 by 22 foot metal building, issued August 2025

02

Column locations matched to the supplier's drawings

03

A foundation design the client's contractor can submit for permit

04

SERVICE

Have a site like this?

Tell us the constraint. We will tell you what it takes to permit it.

FREE CONSULTATION

Let's talk about your upcoming project.

Frequently Asked Questions

What did JRH Engineering design for the metal building in Alvin, TX?

JRH Engineering designed the foundation for a pre-engineered metal building of about 43 by 22 feet: a 4-inch slab with reinforced grade beams and extra reinforcement at each column.

What is a grade beam bump-out?

A bump-out is a thickened section of the grade beam where a column lands, so the building's load has a stronger path into the ground.

Does a small metal building need an engineered foundation?

Even a building of about 960 square feet delivers its load at a few columns, so the foundation is designed for those loads. Requirements vary by city and county, so check with the local building department.

bottom of page